My Replication of Stan's Plate Design

f3dfox
Posts: 14
Joined: Sun Nov 19, 2017 11:46 pm

Re: My Replication of Stan's Plate Design

Post by f3dfox » Mon Nov 20, 2017 3:00 am

Can anybody elaborate on the coil winding? I looked over this with an expert in electronics, but we are not sure about the turns and rows...
Any info is greatly appreciated.
2nd - any answer to how to bind the tubes in series? I can only think of a parallel combination...
עם ישראל חי - The Nation of Israel forever

User avatar
h2oadmin
Site Admin
Posts: 79
Joined: Sun Nov 19, 2017 2:54 am

Re: My Replication of Stan's Plate Design

Post by h2oadmin » Mon Nov 20, 2017 3:00 am

Here is a video on winding Stan's 8xa coil:

http://www.youtube.com/watch?v=TsIHxg30bC4

The tubes can be connected in series as well, but you will have to use higher voltage.
The parallel setup requires less voltage.
Praise the Lord and Pass the Ammunition!
Job 28:22-23

Post Reply